Hi
We have one problem come up.
We only see the problem when we run it on the laptops we send to our clients.
I can reproduce it like that: When we open a model with about 20 objects in the Pick sample, clicking on certain parts returns the wrong part via the ipick.GetItemAt() call.
So when we click on part 1 the actual part that comes back is for the part 5. Also Clicking anywhere in the background returns the part 1. If we hide the part 1 then it start returning a different part.
We only see this when we run on these particular Dell laptops.
This particular installation included KernCAD version 4.3.3771.0
Best Regards,
JM
Problem with IPick on Dell laptops
Re: Problem with IPick on Dell laptops
Hi JM
I could not reproduce this, but we have made a change there. Try 4.3.3821 or 4.4.3820
Gerard
I could not reproduce this, but we have made a change there. Try 4.3.3821 or 4.4.3820
Gerard
Re: Problem with IPick on Dell laptops
JM,
This can help too, if you still have the issue:
In 4.3.3830 and 4.4.3829 we have added two new context options for selection in Modify mode. See more at http://www.dynoinsight.com/Help/Compone ... ction.aspx
Gerard
This can help too, if you still have the issue:
In 4.3.3830 and 4.4.3829 we have added two new context options for selection in Modify mode. See more at http://www.dynoinsight.com/Help/Compone ... ction.aspx
Gerard